+- NightOwl Forums (https://forums.nightowlpro.com)
+-- Forum: The Crypt (https://forums.nightowlpro.com/forumdisplay.php?fid=12)
+--- Forum: Off Topic (https://forums.nightowlpro.com/forumdisplay.php?fid=9)
+--- Thread: New Pt1 Glove.. (/showthread.php?tid=12136)
New Pt1 Glove.. - myers04 - 06-12-2006
i made this to look like the glove that burned guy builds in the opening shots of anoes 1 if you look at the screen cap the back plate is not brass but copper and the blades are more strait then curved....i wanted to make a glove that looked like that so here it is i will have another one done sooner with a leather glove and all but i just made these templates and wanted to try em.....
New Pt1 Glove.. - Jason-V - 06-12-2006
Looks good.. was the solder spills that heavy/runny in the cap?? I think if you could get a clean sweep of solder on the blades/finger it would look better!
New Pt1 Glove.. - Barzo 19 - 06-13-2006
looks great man. good job
Chris
New Pt1 Glove.. - myers04 - 06-13-2006
yeah the solder is kinda runny i didnt take my time on this seeing i just wanted to get it done...and made sure my new templated would work properly....but i hear what your saying i just started using this solder for the blades and i realize you just need a very little flux on the area you are using this stuff on....thanx for the post though..
New Pt1 Glove.. - Jason-V - 06-13-2006
no prob man.. templates look great..!!! Just use little solder and flux! It can be a hoe bag!
New Pt1 Glove.. - necrolover - 06-13-2006
You just get better and better man. Keep up the good work. :thumbsup:
New Pt1 Glove.. - myers413 - 06-13-2006
nice tom of which pt of the movie it is ?
