+- NightOwl Forums (https://forums.nightowlpro.com)
+-- Forum: The Crypt (https://forums.nightowlpro.com/forumdisplay.php?fid=12)
+--- Forum: Off Topic (https://forums.nightowlpro.com/forumdisplay.php?fid=9)
+--- Thread: Wed Clay (/showthread.php?tid=7145)
Wed Clay - jwolf1277 - 08-14-2005
i picked up 50 lbs of wed the othe day and I am working on a jason part 3 undermask, anyway this stuff is very soft and i am used to oil, any pointers would be greatly appreciated, roughing out is a snap but detailing seems to be a little tricky, are you supposed to let it dry out little beofre putting a a lot of detain in. and also what about the casting process? anything different, it just seems like should let it dry out a little, I\'m think that em210 would possible cause the sculpture to e damadged slightly when pushing it againt the sculpture for the dividing wall, just let me know if you have any pointers. Thanks...
Wed Clay - VF31 - 08-14-2005
when getting to detail definatly have it pretty dry so the lines and details will be defined enough.
and im pretty sure once the sculpture is finished u let it dry a good amount and spray it with a krylon clear coat
Wed Clay - mike - 08-15-2005
while its moist u build up the surface and shape then after it dries some u can add detail if u sculpture within a hour or so anyway then u nto ready for detailing it will dry up some then u can add details it will get harder and u cna clear coat it then add the wall