+- NightOwl Forums (https://forums.nightowlpro.com)
+-- Forum: The Crypt (https://forums.nightowlpro.com/forumdisplay.php?fid=12)
+--- Forum: Off Topic (https://forums.nightowlpro.com/forumdisplay.php?fid=9)
+--- Thread: Drilling And Sanding (/showthread.php?tid=2796)
Pages:
1
2
Drilling And Sanding - dxfan - 10-19-2004
okay i get a pair of blanks from no face i cuy off the extra material around the sides with scissors (hope that was right) and sanded it to my liking
now what size drilll should i use for the holes? and what about the e yes this is my first time so ant advice is welcomed
Drilling And Sanding - englundisgod - 10-19-2004
for they eyes you can use a dremel (i aint got one) so after using the lagest bit to drill what is left of the eyeholes if u aint got a dremel use a roundfile (3/16") like what you use to sharpen a set chainsaw teeth
Drilling And Sanding - Eddie - 10-20-2004
You can honestly use a pair of scissors to cut out a blank. Styrene is a very soft plastic.
Eddie
Drilling And Sanding - Jason-V - 10-20-2004
Quote:You can honestly use a pair of scissors to cut out a blank. Styrene is a very soft plastic.honestly i think he said he did
Eddie
Drilling And Sanding - dxfan - 10-20-2004
honostlly what size srill bit should i use for the holes?
Drilling And Sanding - puckface - 10-20-2004
Honestly, whatever size matches the size of the imprint on the blank
Man, this is fun....honestly
Drilling And Sanding - Jason-V - 10-20-2004
honestly you should use 3/8" bit
Drilling And Sanding - puckface - 10-20-2004
What kinda man throws a shoe....honestly?
Drilling And Sanding - Jason-V - 10-20-2004
Quote:What kinda man throws a shoe....honestly?to be quite honest.. i dont know!
Drilling And Sanding - lowerleftmandible - 10-20-2004
I\'ve never owned a Hockey Mask before but they can be cut with scissors?!?!?!? Doesnt that seem a little fragile?