Clay Press Question? - Printable Version +- NightOwl Forums (https://forums.nightowlpro.com) +-- Forum: The Crypt (https://forums.nightowlpro.com/forumdisplay.php?fid=12) +--- Forum: Off Topic (https://forums.nightowlpro.com/forumdisplay.php?fid=9) +--- Thread: Clay Press Question? (/showthread.php?tid=12102) |
Clay Press Question? - HorrorFX - 06-10-2006 Hey guys I want to do a clay press. But I am curious to know as to if you can melt water-based clay? Or can it only be done with oil-based clay? Take care guys -Chris Clay Press Question? - Mask Murderers - 06-10-2006 As far as I know you can\'t melt water based clay & to be honest I would not try, just use good old oil based. You can not just melt the clay & put it into a plaster mold so note that, you have to use a silicone mold or alginate mold of the piece you want to cast. You can however put plastic on the inside of a plaster mold & brush clay in over the plastic but you will lose almost all the detail but you will have the same forms & shapes as the peice you are trying to duplicate. Clay pressing or pouring are usually done is flexible molds. hope that helps a bit. Clay Press Question? - HorrorFX - 06-10-2006 Ah ok. Thanks for your help, Bob. -Chris Clay Press Question? - sidewinder420 - 06-10-2006 Quote:As far as I know you can\'t melt water based clay & to be honest I would not try, just use good old oil based. You can not just melt the clay & put it into a plaster mold so note that, you have to use a silicone mold or alginate mold of the piece you want to cast. You can however put plastic on the inside of a plaster mold & brush clay in over the plastic but you will lose almost all the detail but you will have the same forms & shapes as the peice you are trying to duplicate. Clay pressing or pouring are usually done is flexible molds. hope that helps a bit.I clay-pressed a two piece stone mold and it worked just fine. Just wanted to add that to say that it can be done that way.. :thumbsup: Clay Press Question? - nightmareofdarkness - 10-09-2006 ok pardon my ignorance please,but what is a clay press?how do you do it?can it only be done in a plaster mold? |