Hock Question - Printable Version +- NightOwl Forums (https://forums.nightowlpro.com) +-- Forum: The Crypt (https://forums.nightowlpro.com/forumdisplay.php?fid=12) +--- Forum: Off Topic (https://forums.nightowlpro.com/forumdisplay.php?fid=9) +--- Thread: Hock Question (/showthread.php?tid=15454)

Hock Question - Darth Veach - 12-18-2006 OK, I am working on a few blanks right now and I was wondering... Judging from the screen caps I made, it looks like the Part 8 has the same size holes as a 7. IS this correct. The look smaller than any 3-6. Mike or anyone else have any thoughts. I am currently using a 3/8 bit for my 3 and 6 and a 5/16 bit for the 7. Hock Question - VF 31 - 12-18-2006 i like the holes on the 8 too be a tad smaller than the 3-6...so yea basically the size the 7 holes are...which arent actually that small...but they are smaller than others....the part 9 had even smaller holes than the 7 though, but yea....lol Hock Question - mike - 12-18-2006 the 8 holes are smaller not sure if tis the same as the 7 but its smaller than normal Hock Question - Ruste Dowg - 12-19-2006 As far as i can tell the holes on the p8 do look a very similar size to the p7, which i hadn\'t noticed before, i always thought the holes on the p7 were even smaller but they do look very close in size to the p8 which are smaller holes than the p3/4/6 but hey it\'s just the way i see it, could be wrong! why don\'t you pm Ken Tarallo, he may be able to help :thumbsup: Hock Question - Darth Veach - 12-19-2006 Yeah, here are the screen caps I\'m going by. The PT8 definitley looks slightly smaller than a 3 or 4 as shown.