+- NightOwl Forums (https://forums.nightowlpro.com)
+-- Forum: The Crypt (https://forums.nightowlpro.com/forumdisplay.php?fid=12)
+--- Forum: Off Topic (https://forums.nightowlpro.com/forumdisplay.php?fid=9)
+--- Thread: Hockey Mask Question For Dowg And Other Makers (/showthread.php?tid=21281)
Hockey Mask Question For Dowg And Other Makers - Darth Veach - 12-09-2007
I am wanting to customize one of my blanks to something similar to a VS battle Hockey Mask, but more my own design. My question is, when you guys do the cuts into the mask, are you just using a dremel engraving or cutting bit and just being careful not to go thru the mask? Any suggestions are appreciated.
Hockey Mask Question For Dowg And Other Makers - puckface - 12-09-2007
depending on the thickness, a dremel is fine to use to make the cuts and slashes...like you said, just be careful not to go to deep and you are fine
Hockey Mask Question For Dowg And Other Makers - Darth Veach - 12-10-2007
Cool, it's what I figured. Dowg made a VS battle Hockey Mask for Rahl that I think is just amazing and I wanted to do one that had some similar cuts in it. I'll post pics when I get going on it.
Hockey Mask Question For Dowg And Other Makers - Ruste Dowg - 12-10-2007
Hey mate, i use soldering iron with a gound down tip for the more finer detail but a dremil will work fine with the right attatchments, just remember to take your time <img src=\"style_emoticons/<#EMO_DIR#>/tongue.gif\" style=\"vertical-align:middle\" emoid=\"
\" border=\"0\" alt=\"tongue.gif\" /> Best thing about a soldering iron is that if you do go through the mask you can melt the platic back over in the grove to repair it <img src=\"style_emoticons/<#EMO_DIR#>/thumbsup.gif\" style=\"vertical-align:middle\" emoid=\":thumbsup:\" border=\"0\" alt=\"thumbsup.gif\" /> Email me if you need anymore help.