+- NightOwl Forums (https://forums.nightowlpro.com)
+-- Forum: The Crypt (https://forums.nightowlpro.com/forumdisplay.php?fid=12)
+--- Forum: Off Topic (https://forums.nightowlpro.com/forumdisplay.php?fid=9)
+--- Thread: Help With Ultracal Mold Repair? (/showthread.php?tid=27385)
Help With Ultracal Mold Repair? - carter1010 - 02-09-2009
Ok, I screwed up my mold of Pinhead. I am trying to save him. The grid area was thin and brittle and some of the areas have broken off. Is there any type of epoxy that I can use to repair the inside detail of the mold? I tried the ultra cal, but even after wetting it could not get it to stick. Can I use wire glued in place with something? Suggestions very much appreciated from those with mold repair experience. thank you,Brian
Help With Ultracal Mold Repair? - Ruste Dowg - 02-09-2009
Try here mate<a href=\"http://www.theeffectslab.com/forums/viewtopic.php?t=3137\" target=\"_blank\">http://www.theeffectslab.com/forums/viewtopic.php?t=3137</a>