+- NightOwl Forums (https://forums.nightowlpro.com)
+-- Forum: The Crypt (https://forums.nightowlpro.com/forumdisplay.php?fid=12)
+--- Forum: Off Topic (https://forums.nightowlpro.com/forumdisplay.php?fid=9)
+--- Thread: Melting Metal Wire (/showthread.php?tid=3474)
Pages:
1
2
Melting Metal Wire - gmyers - 11-28-2004
This may seem dumb...i\'m not sure, don\'t really work with metal. Can you make metal for flexible for heating it, i\'m sure u can right? what level for an oven and how long? I should i have a special tray to keep the metal wire on when i heat it?
Melting Metal Wire - SPAZ - 11-28-2004
yeah :blink:
try it lol
It will blow it up
Melting Metal Wire - cap10rhodes - 11-28-2004
:blink: You do not want to put metal in a microwave. You could blow the damn thing up. No metal at all, no matter how low of a setting you put it on. :blink:
Melting Metal Wire - gmyers - 11-28-2004
lol stupid me.........what about an oven?
Melting Metal Wire - farid_krueger - 11-28-2004
Quote:yeah :blink::lol: :lol: LOL!!!
try it lol
It will blow it up
Melting Metal Wire - cap10rhodes - 11-28-2004
Use a blow torch and hold the metal with a pair of rubber handled pliers.
Melting Metal Wire - gmyers - 11-28-2004
alrite thanks cap!
Melting Metal Wire - cap10rhodes - 11-28-2004
No problem. Just don\'t put it in the microwave!!!!! LOL
Melting Metal Wire - Jason-V - 11-28-2004
I bend 2 inch rods all the time in the shop.. i heat it with a Oxy/acetylene torch,.. but i would get you a torch,, propane would be fine.. or get the Mapp Gas.. its burns 33% hotter than propane.... just dont tell Hank Hill you dinddnt buy propane!!!
Melting Metal Wire - gmyers - 11-28-2004
lol ok thanks man. I\'m going to home depot tomorrow. They should have a torch right?