Melting Metal Wire

[🪦 gmyers ●]

This may seem dumb...i\'m not sure, don\'t really work with metal. Can you make metal for flexible for heating it, i\'m sure u can right? what level for an oven and how long? I should i have a special tray to keep the metal wire on when i heat it?

[🪦 SPAZ ●]

yeah :blink:
try it lol
It will blow it up

[cap10rhodes]

:blink: You do not want to put metal in a microwave. You could blow the damn thing up. No metal at all, no matter how low of a setting you put it on. :blink:

[🪦 gmyers ●]

lol stupid me.........what about an oven?

[🪦 farid_krueger ●]

yeah :blink:
try it lol
It will blow it up

:lol: :lol: LOL!!!

[cap10rhodes]

Use a blow torch and hold the metal with a pair of rubber handled pliers.

[🪦 gmyers ●]

alrite thanks cap!

[cap10rhodes]

No problem. Just don\'t put it in the microwave!!!!! LOL

[🪦 Jason-V ●]

I bend 2 inch rods all the time in the shop.. i heat it with a Oxy/acetylene torch,.. but i would get you a torch,, propane would be fine.. or get the Mapp Gas.. its burns 33% hotter than propane.... just dont tell Hank Hill you dinddnt buy propane!!!

[🪦 gmyers ●]

lol ok thanks man. I\'m going to home depot tomorrow. They should have a torch right?