Mask Finishing Question

[🪦 JasonV123 ●]

a dremel can only do so much. whats the best way to get all the little imperfections off of a masks surface? anyone have any suggestions?-Matt

[🪦 D-bach ●]

naptha and some sand paper, but a dremel should beable todo it all if you using the right attachment.

[🪦 JasonV123 ●]

I usually use assorted felt tipped attachments. are there any other you can recommend?

[🪦 Dr.Killjoy ●]

I mainly use a dremel with different felt tip attachments also. I use the felt bullet shaped attachment most of the time. For me that's been the best. I've cleaned up masters that looked totally ruined with the dremel and you would never know the difference. Some times I'll use some of the round grinding bits that have a very small ball on the end to get into hard to reach areas. Also if the area looks rough like I went in with a dremel I do what D-bach said and then in the end stipple a little latex over it to smooth out the area.