Pt. 6

[THE_SHAPE]

Just go to a hardware store and look...you cant miss them

[🪦 mike ●]

[url=\"http://www.rivetsplus.com/store/orderitems.asp?pid=7043&cid=156&sourcepage=selectparts%2Easp%5F%5Fcid%3D156\"]rivets[/url]


there ya go there are tons of styles of rivets jsut helping u out

[GBeninati]

I wouldn\'t use the pop rivet gun
just pull the nail out of the rivet
put it in and tapp the back (inside) with a hammer to flatten it
unless you want to give me ten bucks for my rivet gun :lol:

[🪦 Cthulhu ●]

im glad you posted that GBeninati those rivit guns on the site were kinda expensive.And thanks for the site mike should i get the open end rivet or closed end???? but thanks again guys for your help. later

[GBeninati]

I FORGOT TO MENTION...
if you are going to do the rivets with the hammer method you will need to get washer of the corresponding size
you can also get the rivets at lowes or home depot

[🪦 mike ●]

well my rivet gun cost me liek 15.00 lol but its not needed jsut makes things eaiser but u can goto lowes,homedepot or any otehr hardware palce to get them

[🪦 gmyers ●]

Hey Mike your good at hockey masks, since we\'re helping everyone out, wanna help me out lol? Well I have a Hockey Mask that is SUPER thick. It\'s fiberglass and I have to superglue that snap rivets in just to keep the straps on. Do I have any other way? I mean I don\'t need to make the hole bigger, get what I\'m saying?

[🪦 mike ●]

how thick?? they make snaps with all size post it jsut depends on thickness

[🪦 adam ●]

use epoxy, you\'ll have to hammer the snaps to get them off then...