Foam Latex Clown Mask...and A Question

[🪦 Homicidal#9 ●]

hey guys,

this is a foam latex clown mask i got some time ago in a trade. I originally intended on wearing it for halloween since it moves with your features and what not. One problem...it doesnt fit. In the neck and the chin area, the foam is much too thick for me...it either has to sit up on the front of my chin, causing serious pain...or when i pull it down to where it should be, my chin is literally coming out of the mouth hole...is there any way i can cut out the foam from the inside between the chin and neck without damaging the overall mask? Also, can i do this without the mask tearing as a result of the cutting? Any help would be appreciated

Thanks,
Tommy

[🪦 null1 ●]

\'Can\' you do it? Yeah, you can. You\'ll need to use good judgement though.
During \'Grinchmas\' We often had to \'pick\' out the inside nose area, no pun intended. The foam latex was thick so the wearer need a little more room to breath. Just be careful. Like I said, use your better judgement. Cut, pick, twease, whatever works best in your situation :wink:

[FVJ Leatherface]

I have a Foam Latex face prosthetic and when I bought it at Halloween it said exactly in the insructions "cut to needed length" Although mine was a prosthetic and yours is a mask I\'m sure you will be OK. But remember cut only a little at a time so you don\'t mess up! Hope that helps :wink: