Resin Mask Repair

[🪦 Last_of_the_Brunnen-G ●]

I have a blank resin hockey mask that I\'m working on and two of the vent holes are a little too big, so I tried using epoxy to fill them in and redrill then, but the epoxy just wouldn\'t stick to the resin. Now this could be because the epoxy has been exposed to the air too much and so it has gone bad, but I\'m not sure. So I want to ask anyone who has experience with this, what would work for this project?

[🪦 myers04 ●]

I have a blank resin hockey mask that I\'m working on and two of the vent holes are a little too big, so I tried using epoxy to fill them in and redrill then, but the epoxy just wouldn\'t stick to the resin.  Now this could be because the epoxy has been exposed to the air too much and so it has gone bad, but I\'m not sure.  So I want to ask anyone who has experience with this, what would work for this project?

[post=\"103815\"]<{POST_SNAPBACK}>[/post]

go the home depot and get some bondo its filler for car bodys it drys steel hard and you can drill it and it will stick to anything....

[🪦 Jason-V ●]

Yep... walmart has is to.. just reg body filler.. bondo or knockoff brand..