06-23-2004, 03:36 AM
(This post was last modified: 06-23-2004, 04:36 PM by Darth Veach.)
I got 4 blank hockey masks from No-face (they are ABS or styrene) and I\'m itchin\' to get to work on them. In a couple places they have a few bumps, nothing major. Has anyone had any problems with sanding these out?
I am going to make a 3 and 7 for myself from a couple of \'em. Any tips from you experienced customizers? I have an art background and I repainted and restrapped an NFX one I got last year, but these are the first ones I will cut, drill, etc all the way. Is there a particular size drill bit that works best for vent holes? I know the vent holes on a 7 are smaller than the rest of the masks. And I use a Dremel, is there a particular cutting bit that anyone is used to?
I appreciate any response I get.
Thank you!
Chris V.
I am going to make a 3 and 7 for myself from a couple of \'em. Any tips from you experienced customizers? I have an art background and I repainted and restrapped an NFX one I got last year, but these are the first ones I will cut, drill, etc all the way. Is there a particular size drill bit that works best for vent holes? I know the vent holes on a 7 are smaller than the rest of the masks. And I use a Dremel, is there a particular cutting bit that anyone is used to?
I appreciate any response I get.
Thank you!
Chris V.