04-20-2004, 04:59 PM
Without a drill and/or a Dremel you\'re kinda stuck. What I do to take rivets off is drill out the center and much as I can, then I take a pair of angled wire cutters to cut off the end of the rivet, then I use them to pry up the washer. After that the top usually just falls off. I wouldn\'t recomend trying a screw driver, that will put a LOT of pressure on the edge of the mask and will msot likely crack it. If you don\'t have the right tools now, wait until you have them, or you\'ll probably end up wrecking the mask.