New Pt1 Glove..

[🪦 myers04 ●]

i made this to look like the glove that burned guy builds in the opening shots of anoes 1 if you look at the screen cap the back plate is not brass but copper and the blades are more strait then curved....i wanted to make a glove that looked like that so here it is i will have another one done sooner with a leather glove and all but i just made these templates and wanted to try em.....

[🪦 Jason-V ●]

Looks good.. was the solder spills that heavy/runny in the cap?? I think if you could get a clean sweep of solder on the blades/finger it would look better!

[🪦 Barzo 19 ●]

looks great man. good job

Chris

[🪦 myers04 ●]

yeah the solder is kinda runny i didnt take my time on this seeing i just wanted to get it done...and made sure my new templated would work properly....but i hear what your saying i just started using this solder for the blades and i realize you just need a very little flux on the area you are using this stuff on....thanx for the post though..

[🪦 Jason-V ●]

no prob man.. templates look great..!!! Just use little solder and flux! It can be a hoe bag!

[🪦 necrolover ●]

You just get better and better man. Keep up the good work. :thumbsup:

[🪦 myers413 ●]

nice tom of which pt of the movie it is ?