Opinions

[🪦 puckface ●]

whats a good clay to get when building the wall before molding? are there any local places you can usually pick it up at?I know a few places I can get some good stuff, I just wanted others opinions before ordering and waiting a while to get itthanks

[🪦 Dahone ●]

Laguna Clay's EM-210 White clay....

[🪦 puckface ●]

thats the exact clay I had in mind and was going to order...theres a place in-state where I could get that....I was just wondering if there were any alternativesthansk rich

[🪦 October Rust ●]

Honestly, not really.

[🪦 Dahone ●]

I have used WED when I had nothing else.....Make sure you either make your dividing line with a marker or with an airbrush first.....that way you'll be able to tell the difference between your sculpt and the wall.

[🪦 YOUR BOOGEYMAN ●]

One trick I have seen used often in the FX shops by the mold makers: if you dont have em-210 and you only have WED clay for your walls is to baby powder the area where the wall is going to touch the sealed wed sculpture. Just apply the baby pwder with a chip brush and gently blow off the excess. Then lay down your wed clay strip.This helps greatly to release the Wed clay from the sculpture and it will help you see where the clay wall touches the Wed sculpture. This trick also works on oil based sculptures if you want to use Wed clay for your dividing wall.Casey