New TCM sculpt, in the rough

[🪦 Hauntmaster9 ●]

The metal bars are in the corners of the mouth.

[🪦 mike ●]

there not bars there wire it goes all around then mouth it was used to stretch the opening

[🪦 Mask Murderers ●]

I suggest adding the wire after your done the mask to give it a more realistic feeling. Your sculpture is looking good, keep up the good work.

Bob

Mask Murderers

[🪦 Hauntmaster9 ●]

Are you going to do the eyelashes??

[🪦 killnskin ●]

It had eye lashes? i thought that was just were the inside of the eye hole was mared up. but i will be putting hair on the eye browes, and as for the wire, i still dont see what you guy are talking about. to me it looks like just folded over mask.

also... ill be putting updated pics here.

[url=\"http://www.geocities.com/killnskin85\"]http://www.geocities.com/killnskin85[/url]

[🪦 Hauntmaster9 ●]

There take that pic into a photo editing program and zoom in, you can see the wire isn\'t just latex folding over. Now zoom in nice and close on the eyes, you can see the eyelashes are on the outside of the mask and not coming from the inside, you can see that better on the right eyehole.

[🪦 killnskin ●]

I see everything very clearly now, and thanks alot for the great reference.

[🪦 killnskin ●]

I think im pretty much finished, but i cant figure out the fore head wound, every time i resoulpt it, it looks bad. let me know what you think.

[🪦 Hauntmaster9 ●]

Hey heres my two cents, I think it\'s almost there but not quite yet. Heres a few points I thought about while comparing the pic of your sculpture to the mask above. Nose is a bit too wide, the right corner of mouth could use a bit of work, the chin should come out a bit more and almost overlap the "lip" a bit at one point, a tad more definition of the wrinkles on the neck. Just my opinion, you\'ve already got a killer sculpture I\'m sure it\'ll make an awesome mask.

[GBeninati]

the space between the two eyes should only be as wide as the width of each individual eye