Perfect Myers Molding

[🪦 HorrorFX ●]

hey guys
i must know from the pros how to mold a myers mask the proper way, i saw Lees first puul of his second stab and the mold-line was paper thin, how do i acheive that?
thank you in adavance
take care
-chris

[🪦 goaliehack ●]

Because clearly molding a Myers mask is a whole new world in comparison to other sculpts.

[🪦 The13thDreamShape ●]

LOL

well, just make a normal mold... and pull the latex pull out within a half hour of molding

[SuperDanDrista]

Wait a sec...do you mean the seamline???? Getting the seam small just takes careful planning of the mold wall ...and practice

[🪦 Hauntmaster9 ●]

LOL

well, just make a normal mold... and pull the latex pull out within a half hour of molding

[post=\"84664\"]<{POST_SNAPBACK}>[/post]

What! Don\'t do that let it cure first. Just make sure the two pieces of the mold fit together tightly, and if you want a perfect seem use a dremel with a cotton bullet or even a felt wheel works pretty well and some thinner on that seam.

[🪦 Ben_Forsaken ●]

yeah, let the latex dwell for at least a half hour and then let it cure overnight.

You try and pull a mask out of a mold in 30 minutes and you\'re just gonna be pulling chunks.

[🪦 gmyers ●]

That some\'s it up. Are you also asking how you make your latex thinner?

[🪦 HorrorFX ●]

That some\'s it up.  Are you also asking  how you make your latex thinner?

[post=\"84703\"]<{POST_SNAPBACK}>[/post]

nope, i just needed to know how to make the barieer wall perfect, like should the wall go around the back on the ears? or around the ear lobe? Im so sorry for all the questions, i just want to get this right
take care
-chris

[🪦 SPAZ ●]

I go around the top and the back of the ears

[🪦 HorrorFX ●]

I go around the top and the back of the ears

[post=\"84710\"]<{POST_SNAPBACK}>[/post]

gotcha, thanks spaz and thanks everyone for your help
-chris