04-29-2008, 10:40 PM
I tried the putty stuff for the cheap ones, and the fit seems a little thick. But I don't think I can modify the putty? It simply stays solid and does not soften in hot water. The piece in general seems kinda thick, and would seem impossible to to fit with bottom ones at the same time. It is kinda like having buck teeth. The ones from DD look thinner from the pics, are they? I guess I will have to buy a lot of pellets somewhere to try these cheaper ones again as I don't think the putty is meltable. Should there be a slit that your teeth slide down into, or just the impression to snap on? Also I think the bulky and heaviness causes the piece to pull down and off more.Need something a lot lighter and thinner.
Received:
DMC: stunt mask 5/sweater (Great products poor/slow communication.)
NIGHTOWL: Vengeance (Great mask, very happy with it.)
Suckface: Freddy left hand (Great and very fast service overall.)
Crash: Part 7 Hockey Mask (Great Hockey Mask, and very fast service.)
JC: H20 Replica knife (Awesome knife, and shipped very fast! Great service overall.)
Maggot Head Hood (Great hood! High quality, just like all of Justin\\\'s products.)
Crash: JGTH Hockey Mask.
Bellamy: Part 8 hood.
DWN Productions: HellFace
Custmcraft: VS Glove
DMC: stunt mask 5/sweater (Great products poor/slow communication.)
NIGHTOWL: Vengeance (Great mask, very happy with it.)
Suckface: Freddy left hand (Great and very fast service overall.)
Crash: Part 7 Hockey Mask (Great Hockey Mask, and very fast service.)
JC: H20 Replica knife (Awesome knife, and shipped very fast! Great service overall.)
Maggot Head Hood (Great hood! High quality, just like all of Justin\\\'s products.)
Crash: JGTH Hockey Mask.
Bellamy: Part 8 hood.
DWN Productions: HellFace
Custmcraft: VS Glove