11-03-2012, 05:31 PM
Ok sorry for the long delay on updating this sculpt but I had the worst luck with it lol . Keep in mind that this is only my 2nd sculpt . I had everything going smoothly until the mold locked on me and I tried slowly to pry it open and the back side cracked and broke really bad . So I wasn\'t even sure if I could save it . Then by looking at it over and over , I decided to peel off the remainder of the back mold and just attempt to re-mold the back and hope that the seam line isn\'t too rough and both halves fit good . Istill have to do clean up on this thing and trim it in alot of areas but for all the trouble I had with this piece and for being my 2nd try at mask making , I think it came out half decent . Hope you guys like it . Now i\'m doubting this will be a mask that i\'ll sell copies of as I can\'t charge too little as I would have to cover the cost of shipping and materials . But it was fun and hopefully the next sculpt will come out better after I study a few Alfry dvds ;-)