Help! Finished

[🪦 Jason-V ●]

looks great man!

[🪦 Soldier48 ●]

Looks good man

[🪦 antisocial1 ●]

LOL! Just keep up the patience, you\'re doing great so far! I\'m not too familiar with what it should look like, so I can\'t give any suggestions except to keep up the good work!!!

[🪦 puckface ●]

I dont know if it really matters when painted up....but Ive always wanted to see an axe cut that was deep....instead of just a cut or sumthn

[🪦 onoman ●]

Great job as always Mark!!

[🪦 Pugsly ●]

Looks great so far.......

[🪦 Ruste Dowg ●]

ohh! that rocks!!

[🪦 sidewinder420 ●]

OK. I\'ll give this a try.

The right ear is too small. The tip should just pass the mid center of the eye line.

I think the reason your having an issue is you don\'t have the dimensions of the head right. He needs a longer face.
His right ear is WAY too low. The bottom of that ear should line with his upper lip.

The left side of his head needs more deformity to it. Needs more arch.

That\'s it for now. Work on that and when you got it, bring it before me and I\'ll nit-pick some more.

Looks alright so far...

[🪦 SlasherHouse ●]

Looking good bro!

[🪦 travsall ●]

I\'ll give my rundown for ya Mark, since I like this look a lot, and have seen just about every incarnation of it. Off hand it looks great, really nice rough out and start to a great piece, couple things caught my eye that could use a little attention. First off, I think you nailed the left side (his left) with the detailing, it\'s going to come out fantastic, the ear as well looks good as it is. The right side though I think looks a tad big, a little over exagerated, especially the eye, it is slightly bigger but not that much. That whole side of head, and forehead looks a tiny bit big too, buldging a little maybe is a better way to put it. Not a ton, just enough to make me notice (mind you I am pretty anal with details) The cheek is just a tiny bit sharp too, just a little softer there would even things out some. The chin is good overall, but maybe a tiny bit sharp there too.
Hope any of that can be helpful, just my overview. Hope it doesn\'t push my stuff further back too :wink: It\'s gonna turn out to be one hell of a piece, can\'t wait to see it done.