Drilling And Sanding

[🪦 dxfan ●]

okay i get a pair of blanks from no face i cuy off the extra material around the sides with scissors (hope that was right) and sanded it to my liking

now what size drilll should i use for the holes? and what about the e yes this is my first time so ant advice is welcomed

[🪦 englundisgod ●]

for they eyes you can use a dremel (i aint got one) so after using the lagest bit to drill what is left of the eyeholes if u aint got a dremel use a roundfile (3/16") like what you use to sharpen a set chainsaw teeth

[Eddie]

You can honestly use a pair of scissors to cut out a blank. Styrene is a very soft plastic.

Eddie

[🪦 Jason-V ●]

You can honestly use a pair of scissors to cut out a blank.  Styrene is a very soft plastic.

Eddie

honestly i think he said he did

[🪦 dxfan ●]

honostlly what size srill bit should i use for the holes?

[🪦 puckface ●]

Honestly, whatever size matches the size of the imprint on the blank

Man, this is fun....honestly

[🪦 Jason-V ●]

honestly you should use 3/8" bit

[🪦 puckface ●]

What kinda man throws a shoe....honestly?

[🪦 Jason-V ●]

What kinda man throws a shoe....honestly?

to be quite honest.. i dont know!

[🪦 lowerleftmandible ●]

I\'ve never owned a Hockey Mask before but they can be cut with scissors?!?!?!? Doesnt that seem a little fragile?