01-12-2007, 01:12 AM
the costume looks great but for my tie i took a regular tie you can use acryllic, or facric paint (I think it\'s latex based) and paint on the design
take painters tpe cut off a strip ans cut the piece length ways about 1/4" thick sketch out the design with chalk and tape it off for 1/4\' pinstrips (stark white) and fire engine red to fill in the pinstrips I\'v seen the greyish blue ones also weather the apron i am guessing your apron is vinyl its doesnt adgere blood or paint well you can try sanding it with 400 grit sandpaer to dull it i would have gotten a neoprene apron it is great for the blood.your going to want to apply the blood while apron is laying down with vinyl it will all run off and not dry set it down then dry if you wat runns do it while its dow by pouring or flicking that blood that way use water based blood not karo or corn syrup
- Aaron
take painters tpe cut off a strip ans cut the piece length ways about 1/4" thick sketch out the design with chalk and tape it off for 1/4\' pinstrips (stark white) and fire engine red to fill in the pinstrips I\'v seen the greyish blue ones also weather the apron i am guessing your apron is vinyl its doesnt adgere blood or paint well you can try sanding it with 400 grit sandpaer to dull it i would have gotten a neoprene apron it is great for the blood.your going to want to apply the blood while apron is laying down with vinyl it will all run off and not dry set it down then dry if you wat runns do it while its dow by pouring or flicking that blood that way use water based blood not karo or corn syrup
- Aaron