05-16-2007, 09:59 PM
Hi all!Recently I aquired a Rubbermugs Ol' Pizza Face and I'd really like to get it foam filled, however I have questions as to if that can even be done. Here is the situation. The mask is semi-uncut. There is a large slit up the back of the mask so you can wear it and there are holes in the ears for hearing, however the eyes, nose and mouth are all uncut. Personally I've never filled anything so I'm not sure if that can even be done now due to the holes in the ears and slit up the back. If it is possible how much would someone charge for the following...I'd like to have acrylic eyes added to it if possible, if not then I would like to have it filled as is and have the slit in the back sealed as much as possible.If the mask cannot be filled due to these circumstances, what would you recommend for me to seal up the slit in the back as best I can so I can use a foam head display. I was thinking of applying super glue to it, but I'm not sure if that would cause the latex to break down *this is a relatively thick mask* any quicker than normal. If super glue is not an option, what would you recommend me using.Thanks in advance for help with this matter guys I really appreciate it!-Joseph