Homemade Wallmount Mask Stands ?

[🪦 Homicidal#9 ●]

here is what i have used for wall mount stands. I go and buy several of the wood plaques from michael's or another craft store. I then buy some pvc tubing, some 45 degree angle joints and some pvc toppers. I use a drill to cut out the necessary hole in the plaque to fit a piece of around 4-6 inch pvc. I then add the 45 degree joint and add another piece of 12 in to 16 inch pvc. Finally i had the topper. I have used 90 degree angle joints in the past, but i always ended up having to make the initial pvc from the wallmount much longer if i did.take care,Tommy