03-23-2011, 06:30 AM
After the undercoat, I followed Sean's tip of using toothpaste as a spray resistant, it doesn't just fight tar tar 
Here's the base coat of gunmetal gray.
![[Image: odst8.jpg]](http://img.photobucket.com/albums/v162/travsall/odst8.jpg)
![[Image: odst9.jpg]](http://img.photobucket.com/albums/v162/travsall/odst9.jpg)
showing a couple spots where the toothpaste is under.
![[Image: odst10.jpg]](http://img.photobucket.com/albums/v162/travsall/odst10.jpg)
![[Image: odst11.jpg]](http://img.photobucket.com/albums/v162/travsall/odst11.jpg)
Added the center stripe, went with a medium gray, makes the metallic gunmetal stand out nicely!
![[Image: odst12.jpg]](http://img.photobucket.com/albums/v162/travsall/odst12.jpg)
![[Image: odst13.jpg]](http://img.photobucket.com/albums/v162/travsall/odst13.jpg)
After spraying flat black on the area around the visor, and the back detail panel.
![[Image: odst14.jpg]](http://img.photobucket.com/albums/v162/travsall/odst14.jpg)
![[Image: odst15.jpg]](http://img.photobucket.com/albums/v162/travsall/odst15.jpg)
Added UNSC in flat black below the panel.
![[Image: odst16.jpg]](http://img.photobucket.com/albums/v162/travsall/odst16.jpg)
Here's the base coat of gunmetal gray.showing a couple spots where the toothpaste is under.
Added the center stripe, went with a medium gray, makes the metallic gunmetal stand out nicely!
After spraying flat black on the area around the visor, and the back detail panel.
Added UNSC in flat black below the panel.