Help! Finished

[🪦 null1 ●]

Thanks for the comments. While you guys were typing, I was sculpting. This is phase two so let\'s comment on THESE pics now as far as adjustments are concerned. I want you guys to help with each phase. As for the comments, I\'ll go back over the sculpture and adjust as needed. It\'s nice to get input as you go along.
Here is the second phase.... Keep in mind, although it IS a step ahead, often times when sculpted you also take steps back...

[🪦 SPAZ ●]

Damn man
I love it even more now!!!!!!!!!

[🪦 SPAZ ●]

sent ya a pm bro

[🪦 ianfxmen ●]

looking good bro

[Sackface]

love the detail in the faetures

[🪦 SPAZ ●]

do you have a Hockey Mask to hold up to it
I wanna see what it looks like with a Hockey Mask

[🪦 sidewinder420 ●]

You already NEW what it needed. THAT RULES, man. I want one..

[🪦 SPAZ ●]

you going to add the hammer hit on the shoulder?

[🪦 null1 ●]

Sorry, a Hockey Mask wont fit it at this point. It\'s too big. I\'m sculpting it big so once I get a master pull and make copy molds from that, it will be the right size.
When sculpting, I often take pics of the piece at the same angle as a reference pic that I\'m using. In this case I\'m using one of the \'stunt\' pieces as only one of many references. Keep in mind there is no head in the stunt mask so I had to \'wing it\' with the (his) left side of the mouth. I like to over lap the pics to see where I stand on accuracy. Here are the results thus far on a straight away shot of the sculpture and the stunt mask.
By the way, thanks to whomever took the pic of the mask...
Teeth are only there as place holders for now....

[🪦 SPAZ ●]

soooo the teeth are going to be added to the pulls?