Putting Shirts On Mask Displays.

[3pidemiC ●]

I was just curious, is there any technique to putting a shirt to make your mask diplay look nicer? Do you have to cut it? Is there a certain way to wrap it? I am intested in putting a shirt on my new "From Hell" mask. But I am a little unsure on how to go about doing it. Any help would be appreciated. Thanks.

[Ben_Forsaken ●]

personally I just play with it till it looks right. Alot of the excess you can usually shove up into the mask.

[VF 31 ●]

yea just put it around the neck like u would ur own neck and then mess with it till it neatly enough hugs the chest and back of the mask....then tuck in the rest inside the mask and stick the stand in

[3pidemiC ●]

I just put a shirt on my "From Hell" peice. It looks great but I am afraid because the shirt seems to be bending the bottom of it downwards...and it may damange the mask.

[SlasherHouse ●]

Do some adjusting on the shirt and position the shirt in the mask carefully and you should have no problems. Just tweak it a little and it\'ll be fine.

[CreepingDead ●]

I just put a shirt on my "From Hell" peice. It looks great but I am afraid because the shirt seems to be bending the bottom of it downwards...and it may damange the mask.

[post=\"169220\"]<{POST_SNAPBACK}>[/post]

So don\'t put so much of the shirt inside the mask. Simple. Also when you are putting it on a stand, make sure the stand is not grabbing the shirt and pushing it farther in. I owned a From Hell with full shoulders from the master mold, so I know that a shirt will fit on that piece without a problem.

[VF 31 ●]

yea all that is, is the shirt not having enough slack in that area, thus pulling it in.....again just play around with it...dont give up! its easy once u do it once

[VF 31 ●]

just play around with it...

[post=\"169231\"]<{POST_SNAPBACK}>[/post]

ask anyone, im the master at that! :lol: :woot:

[GBeninati ●]

So don\'t put so much of the shirt inside the mask. Simple. Also when you are putting it on a stand, make sure the stand is not grabbing the shirt and pushing it farther in. I owned a From Hell with full shoulders from the master mold, so I know that a shirt will fit on that piece without a problem.

[post=\"169225\"]<{POST_SNAPBACK}>[/post]

I owned the same copy aaron owned, so I second that!!