Question About Ssn

[🪦 puckface ●]

come on guys, we should all know that there are no hockey masks out there that are from the movie molds unless they come from Ken, geez

[🪦 Ken Tarallo ●]

come on guys, we should all know that there are no hockey masks out there that are from the movie molds unless they come from Ken, geez

[post=\"181312\"]<{POST_SNAPBACK}>[/post]

hah hah hah I get the sarcasm! I am talking about this 7 part... sorry for the confusion...

Ken

Adam
look at the mouth area, do you see a dent running down the mouth inbetween the front holes?

[🪦 Ken Tarallo ●]

i do not see them. the only thing i notice is that the cuts are a little diffrent.

[post=\"181307\"]<{POST_SNAPBACK}>[/post]

Cuts are the same This is a bad picture to use but the only one I have, the undermask makes it hard to see
Plus I mean mold marks not cuts put in by hand

[🪦 EVOL ●]

As owing a Part 7 blank from ken left over from pre fiilming of Part 7, I would have to say. There cut differently.

There from the movie mold just adifferent cut. I\'ve talked to my friend, That knows a lot about it and has talked to Ken plenty of times.

Your really not going to find a better person to ask then Ken, SInce he worked on Part 7.


Here\'s pics of the blank, I own left over from Part 7. I do have to thank Ken for this. Thanks!

[you'realldoomed]

i\'m still not seeing it. i\'ll take your word for it.

[🪦 Ken Tarallo ●]

Welcome,
My gift to a hardcore fan

Ken

As owing a Part 7 blank from ken left over from pre fiilming of Part 7, I would have to say. There cut differently.

There from the movie mold just adifferent cut. I\'ve talked to my friend, That knows a lot about it and has talked to Ken plenty of times.

Your really not going to find a better person to ask then Ken, SInce he worked on Part 7. 
Here\'s pics of the blank, I own left over from Part 7. I do have to thank Ken for this. Thanks! 

[post=\"181321\"]<{POST_SNAPBACK}>[/post]

[🪦 Ken Tarallo ●]

i\'m still not seeing it. i\'ll take your word for it.

[post=\"181322\"]<{POST_SNAPBACK}>[/post]

download and blowup the screen cap you will see a slight dent running down the front of the mask, it is hard to see unless angle is right, That is 1 way I know it came off my mold, there are 2 other ways as well..
Then look at one of the blanks or mask you have from me you will see..
The cuts are always going to be slightly different that is a given..

Ken