Mesh Eyes For hockey masks

[🪦 sirbrad ●]

Just curious what methods you use? Do you glue pieces on or use velcro to attach them to the mask directly? I usually wear a mesh invisible face hood underneath, which looks better in higher light areas but also tougher to see. With the mesh attached to the Hockey Mask you can see the mesh in lighted areas, but visibility seems to be better because the mesh has less shadowing than when underneath the Hockey Mask. But at night it still looks good, just less depth in light. Also the hood can be hotter.

[🪦 monteburns ●]

I would hot glue the mesh to the inside of the mask.

[🪦 puckface ●]

you could use a glue gun...usually the glue can peel right off...but if you dont want it permanent just use electrical tape

[🪦 sirbrad ●]

I was wondering what types of glue would work, but yeah I don't think I want it permanent, as I would like to pull them off if needed for use with undermasks. I read that tape would come off due to moisture and breathing etc, but electrical tape sounds like it would work. I also though about gluing velco to the mask, and then just adding the mesh when needed. Or tape, hopefully it doesn't leave any goo behind.

[🪦 sirbrad ●]

I think those little stick on velcros should work great. Although I think the adhesive is permanent. But should not really matter, being they will never be seen anyway. I will just cut out some squares twice the size or so, and stick them on and still be able to take them off later.