Hock Molds

[🪦 FinalOmega ●]

Hey all you Hockey Mask makers!

I\'m planning to make start scultping a Hockey Mask mold, but I have no Idea where to start! What do you use to make the mold, like what material? can someone like write me the specs on doing this please.


Thanks-Kyle

[🪦 josephchoi ●]

i think ultra-cal 30

[🪦 ZombieBloodLust ●]

scilicone...perhaps dragon skin.... expensive but will last a lifetime

[🪦 Ben_Forsaken ●]

I always thought for a Hockey Mask you\'d sculpture it in clay, mold it in silicone, then make a plaster buck from the silicone mold. Then vacuform over the plaster buck.

[🪦 SPAZ ●]

I always thought for a Hockey Mask you\'d sculpture it in clay, mold it in silicone, then make a plaster buck from the silicone mold. Then vacuform over the plaster buck.

[post=\"120648\"]<{POST_SNAPBACK}>[/post]

yeah thats about right

[🪦 FinalOmega ●]

I always thought for a Hockey Mask you\'d sculpture it in clay, mold it in silicone, then make a plaster buck from the silicone mold. Then vacuform over the plaster buck.

[post=\"120648\"]<{POST_SNAPBACK}>[/post]

you know what, spaz tried to explain that to me once, I didnt understand a f***ing thing he was saying!

[🪦 Mutilated ●]

:lol:

Big suprise there.

[🪦 TallDarkandDisfigured ●]

Wouldn\'t that method make your mask a little bigger than your original sculpture? Since your buck would be the same size as the sculpture.
Maybe I\'m missing something simple though...
I\'ve got the urge to give this a try.