08-29-2006, 01:43 PM
Only just seen this.
It\'s going to be difficult bud. Plastics usually discolour unless the melt temperature is constant and it is kept away from air whilst melted. Not something to do if you don\'t have proper extrusion equipment.
The only way i can see for you to go with this would be to do it first with molten wax, then possibly make a mold around it in silicone if the structure isn\'t too complexed. Then pull the wax out and fill the mold with clear resin. Silicone is expensive, and if you aren\'t experienced at mold making, i\'d either get it done via a private commission or forget it altogether.
Other than that, i\'d say you are no further on, sorry
It\'s going to be difficult bud. Plastics usually discolour unless the melt temperature is constant and it is kept away from air whilst melted. Not something to do if you don\'t have proper extrusion equipment.
The only way i can see for you to go with this would be to do it first with molten wax, then possibly make a mold around it in silicone if the structure isn\'t too complexed. Then pull the wax out and fill the mold with clear resin. Silicone is expensive, and if you aren\'t experienced at mold making, i\'d either get it done via a private commission or forget it altogether.
Other than that, i\'d say you are no further on, sorry