Hock Question

[🪦 Darth Veach ●]

OK, I am working on a few blanks right now and I was wondering...
Judging from the screen caps I made, it looks like the Part 8 has the same size holes as a 7. IS this correct. The look smaller than any 3-6. Mike or anyone else have any thoughts. I am currently using a 3/8 bit for my 3 and 6 and a 5/16 bit for the 7.

[🪦 VF 31 ●]

i like the holes on the 8 too be a tad smaller than the 3-6...so yea basically the size the 7 holes are...which arent actually that small...but they are smaller than others....the part 9 had even smaller holes than the 7 though, but yea....lol

[🪦 mike ●]

the 8 holes are smaller not sure if tis the same as the 7 but its smaller than normal

[🪦 Ruste Dowg ●]

As far as i can tell the holes on the p8 do look a very similar size to the p7, which i hadn\'t noticed before, i always thought the holes on the p7 were even smaller but they do look very close in size to the p8 which are smaller holes than the p3/4/6 but hey it\'s just the way i see it, could be wrong!
why don\'t you pm Ken Tarallo, he may be able to help :thumbsup:

[🪦 Darth Veach ●]

Yeah, here are the screen caps I\'m going by. The PT8 definitley looks slightly smaller than a 3 or 4 as shown.