06-10-2006, 03:54 AM
Quote:As far as I know you can\'t melt water based clay & to be honest I would not try, just use good old oil based. You can not just melt the clay & put it into a plaster mold so note that, you have to use a silicone mold or alginate mold of the piece you want to cast. You can however put plastic on the inside of a plaster mold & brush clay in over the plastic but you will lose almost all the detail but you will have the same forms & shapes as the peice you are trying to duplicate. Clay pressing or pouring are usually done is flexible molds. hope that helps a bit.I clay-pressed a two piece stone mold and it worked just fine. Just wanted to add that to say that it can be done that way.. :thumbsup:
[post=\"163909\"]<{POST_SNAPBACK}>[/post]